Browsing by Author "Warrington, Keith"
Now showing 1 - 1 of 1
Results Per Page
Sort Options
Item Adhesion Characterization and Enhancement between Polyimide-Silica Composite and Nodulated Copper for Applications in Next-Generation Microelectronics(ACS Applied Materials & Interfaces, 2024-01-17) Doshi, Sagar M.; Barry, Alexander; Schneider, Alexander; Parambil, Nithin; Mulzer, Catherine; Yahyazadehfar, Mobin; Samadi-Dooki, Aref; Foltz, Benjamin; Warrington, Keith; Wessel, Richard; Zhang, Lei; Simone, Christopher; Blackman, Gregory S.; Lamontia, Mark A.; Gillespie, John W. Jr.As the need for high-speed electronics continues to rise rapidly, printed wiring board (PWB) requirements become ever-more demanding. A typical PWB is fabricated by bonding dielectric films such as polyimide to electrically conductive copper foil such as rolled annealed (RA) copper and is expected to become thinner, flexible, durable, and compatible with high-frequency 5G performance. Polyimide films inherently feature a higher coefficient of thermal expansion (CTE) than copper foils; this mismatch causes residual thermal stresses. To attenuate the mismatch, silica nanoparticles may be used to reduce the CTE of PI. A nodulated copper surface can be used to enhance the Cu/PI adhesion by additional bonding mechanisms that could include a type of mechanical bonding, which is a focus of this study. In this investigation, a 90° peel test was used to measure the peel strength in copper/polyimide/copper laminates containing nodulated copper and polyimide reinforced with 0, 20, and 40 wt % silica nanoparticles. The influence of silica nanoparticles on the peel strength was quantitatively evaluated. Laminates incorporating polyimide films lacking silica nanoparticles had a ∼3.75× higher peel strength compared with laminates reinforced with 40% silica. Their failure surfaces were analyzed by using scanning electron microscopy (SEM), energy-dispersive X-ray analysis (EDX), and X-ray photoelectron spectroscopy to identify the mode of failure and to understand bonding mechanisms. The key bonding mechanism, mechanical interlocking, was achieved when the polyimide surrounded or engulfed the copper nodules when the laminate was created. Post-testing failure surface analysis revealed the presence of copper on the polyimide side and polyimide on the copper side, indicating mixed mode failure. An analytical model was developed to determine the impact of applied pressure, temperature, and time on the polyimide penetration and mechanical interlocking around the copper nodules. The model was validated by measuring the peel strength on another set of specimens fabricated using increased temperature and pressure that showed a 3× increase in peel strength compared to lower temperature/pressure processing conditions. This enhanced adhesion resulted from the lower polymer material viscosity at higher temperatures, which fosters deeper and more complete penetration around the copper nodules during processing at higher pressures for longer durations. The methodology of combining peel testing, viscosity and CTE measurement, SEM/EDX, surface chemical analysis, and penetration depth calculation developed herein enables the calculation of the desired processing parameters to enhance functionality and improve adhesion.